Setting up a Brick Paver Walkway or Interlocking Bricks

The use of Bricks or Pavers to create a sidewalk or patio area complements a home in a way that is unequaled. In addition, setting up a Brick or Paver walkway does not always require a pro.

The secret to installing a Brick or Paver Walkway is to very first correctly prepare the location where the bricks/pavers are to be installed. In addition, string lines must be strung on each side of the walkway.
When the location has been dug, 3/4" gravel stone should be laid in and tamped down firmly. Then 2" of sand, or stone dust should be topped the gravel. Once again the sand/stone dust should be tamped down. Stone dust is preferred. The height in between the tamped down sand and the stringline should equal the density of the brick or paver.

Now that you have a stable base, put a 1" pipeline or ledger board the length of the walkway on either side of the pathway. Then utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will create a level surface location to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Set up a work on both sides of the ready location. These strips will act as your pathway border and assistance to preserve the stability and shape of the walkway. You can get these plastic strip borders at most house improvement shops. The strips ought to be anchored down with 12" galvinized nails. You need to sink these nails into the ground and through the strips every foot.

You can then start to lay the bricks/pavers once this is done. There are lots of patterns you can lay. I especially like the Herring Bone pattern. The key to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger surrounding rows of bricks by 1/2 of a brick to interlock them. This will once get more info again assist keep the integrity of the walkway.

Undoubtedly bricks/pavers will require to be check here cut or divided when constructing the sidewalk. To actually cut/split the brick/paver, lay it in a bed of sand and location the sculpt at a 75 degree angle over the area where you desire to break the brick. If your walkway has curves you will need to buy/rent a wetsaw.

After installing the bricks, construct up the outside edges with additional sand, and after that shovel in the topsoil and pack down securely.
Finally, spread stone dust over the new walkway and sweep into the cracks. Repeat this procedure a couple of times to guarantee the cracks are completely filled. This will complete the interlocking of the bricks and help to get rid of any weed development. Just add yard seed to the outside edges and you need to have a gorgeous entryway to your home within a number of weeks.


In addition, setting up a Brick or Paver sidewalk does not necessarily require a pro. The secret to setting up a Brick or Paver Walkway is to very first correctly prepare the location where the bricks/pavers are to be set up. Now that you have a stable base, place a 1" pipe or journal board the length of the sidewalk on either side of the sidewalk. These strips will act as your walkway border and aid to maintain the integrity and shape of the pathway. Undoubtedly bricks/pavers will require to be cut or divided when building the walkway.

Leave a Reply

Your email address will not be published. Required fields are marked *